Home > Financial Services Information Security Tips > Security Architecture Insider > Firewall redundancy: Deployment scenarios and benefits
Financial Security Tips:
EMAIL THIS
 TIPS & NEWSLETTERS TOPICS 

SECURITY ARCHITECTURE INSIDER

Firewall redundancy: Deployment scenarios and benefits


Mike Chapple, CISSP
03.05.2008
Rating: -3.83- (out of 5)


Digg This!    StumbleUpon Toolbar StumbleUpon    Bookmark with Delicious Del.icio.us   


Many network administrators have considered implementing dual firewalls. It is an expensive option, and the administrator who proposes the idea is likely to encounter a response like "$5,000 for a firewall? Don't we have one of those already?" There are, however, several good reasons to deploy multiple firewalls in your organization. Let's take a look at a few scenarios.

Fault tolerance and load balancing
Many organizations choose to implement dual firewalls in a parallel fashion, as shown in the figure below. When the router is properly configured, this provides the added benefits of fault tolerance and load balancing. Both firewalls should be configured to "fail-safe," that is, in the event of a failure, they should automatically block all traffic. When configured in this fashion, the firewalls provide fault tolerance; when one fails, the other is able to carry the network traffic and keep the failure transparent to users.

The second benefit to this strategy, load balancing, is a performance benefit. The router may be configured to divide traffic between the two firewalls, either on a priority basis or on a fair-share basis. Spreading the traffic out among multiple firewalls in this fashion helps prevent the bottleneck problems that plague many networks.

Enhanced perimeter protection
It's also possible to deploy the two firewalls in a series circuit, as shown in the illustration below. When configured in this fashion, all traffic passing into or out of the network must pass through both firewalls. This setup is sometimes deployed in high-security environments to protect against firewall-specific vulnerabilities. In this case, the two firewalls are from different vendors and may even run on different operating systems.

Protected subnets
The final scenario we'll discuss is shown in the figure below. In this case, secondary firewall(s) are used to protect subnets of the internal network that have greater security requirements than the network as a whole. This type of scenario may be used, for example, to provide an accounting department added protection for sensitive financial data they wish to protect from other internal users.

Overall, the deployment of multiple firewalls offers a variety of benefits, ranging from greater performance to enhanced security. If your security environment warrants this type of scenario and your wallet is big enough, it's definitely an option worth considering.

About the author
Mike Chapple, CISSP is an IT Security Professional with the University of Notre Dame. He previously served as an information security researcher with the National Security Agency and the U.S. Air Force. Mike is a frequent contributor to SearchSecurity.com, a technical editor for Information Security magazine and the author of several information security titles, including the CISSP Prep Guide and Information Security Illuminated.


Rate this Tip
To rate tips, you must be a member of SearchFinancialSecurity.com.
Register now to start rating these tips. Log in if you are already a member.




Digg This!    StumbleUpon Toolbar StumbleUpon    Bookmark with Delicious Del.icio.us   


RELATED CONTENT
Security Architecture Insider
How to get the most out of a SIM
Security information management finally arrives, thanks to enhanced features
Best practices in managing privileged access
Integrating biometric authentication with Active Directory
Entitlement management systems alleviate access control pain points
How to secure SOA
Identity federation standards ease authentication pains
How to implement the NIST role based access control model
NAC fulfills compliance and security needs
Password management best practices for financial services firms

Network security devices for financial institutions
How to get the most out of a SIM
Top NAC challenges include cost, interoperability issues
Banking on policy in next-generation firewall
Intrusion detection system deployment recommendations
How to make business managers responsible for security
Three points to consider before buying an enterprise firewall

RELATED RESOURCES
2020software.com, trial software downloads for accounting software, ERP software, CRM software and business software systems
Search Bitpipe.com for the latest white papers and business webcasts
Whatis.com, the online computer dictionary

DISCLAIMER: Our Tips Exchange is a forum for you to share technical advice and expertise with your peers and to learn from other enterprise IT professionals. TechTarget provides the infrastructure to facilitate this sharing of information. However, we cannot guarantee the accuracy or validity of the material submitted. You agree that your use of the Ask The Expert services and your reliance on any questions, answers, information or other materials received through this Web site is at your own risk.

About Us  |  Contact Us  |  For Advertisers  |  For Business Partners  |  Site Index  |  RSS
SEARCH 
TechTarget provides enterprise IT professionals with the information they need to perform their jobs - from developing strategy, to making cost-effective IT purchase decisions and managing their organizations' IT projects - with its network of technology-specific Web sites, events and magazines.

TechTarget Corporate Web Site  |  Media Kits  |  Reprints  |  Site Map




All Rights Reserved, Copyright 2008, TechTarget | Read our Privacy Policy
  TechTarget - The IT Media ROI Experts